[. . . ] € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. [. . . ] Slide range back so the rear range foot is inserted into the slot of the anti-tip bracket. 1 cm) from the mounting wall, the rear range foot may not engage the bracket. Slide the range forward and determine if there is an obstruction between the range and the mounting wall. Changes to the gas supply must be performed by a qualified service technician. If you need assistance or service, refer to the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, for contact information. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, to contact service. Level Range Determine if you have AquaLift® Technology or Steam Clean by referring to the “Range Care” section of the User Instructions. Place level on the oven bottom as indicated in one of the two figures below depending on the size of the level. To remove the oven bottom: Remove 2 screws at the rear of the oven bottom. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. If burners do not light properly: ■ ■ ■ ■ Turn cooktop control knob to the “OFF” position. Check that the circuit breaker has not tripped or the household fuse has not blown. Check that the gas shutoff valves are set to the “open” position. If a burner does not light at this point, turn the control knobs to “Off” and contact your dealer or authorized service company for assistance. The cooktop “low” burner flame should be a steady blue flame approximately ¼" (0. Under certain conditions, it may take the burner up to 50 to 60 seconds to light. Refer to the Use and Care Guide or User Instructions for proper operation of the oven controls. High flame To adjust standard burner: The flame can be adjusted using the adjustment screw in the center of the valve stem. If the “low” flame needs to be adjusted: Adjust Oven Bake Burner Flame (if needed) 1. [. . . ] Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Replace the LP gas orifice spud with the correct Natural gas orifice spud. Slide the front of the bake burner to the side to remove tab from front of oven. [. . . ]